
Filters are good, very good. Better media than the originals and I think they will last a long time. Fit is the issue. Each filter has an internal 3/4" shaft extension that prevents the filter from sealing against the base of the motor housing. If you trim it off, they work perfect. A dremel tool is recommended with a cutting wheel. Put painters tape around the base of the filter inside to prevent the shavings from sticking to the filter media as you cut the extension off.
They will fit without this modification, but the holding nut will only go on for half of its threads and I am not confident about the seal at the base.
I was paying $19.00 for one and the quality was very poor they did not last very long I was very impressed with the quality of these filters they are a much heavier filter I’m sure I will get twice the life expectancy out of these. Only paid a little bit more for two than I was paying for just one awesome deal!
I used these on my craftsman shop vacuum , they work fine with a slight modification. If your looking for a direct replacement, keep looking
Filters are interchangeable with OEM filters at somewhat less cost per filter. See no difference in filtration from original filters.
Perfect replacement filter. Filters are always pricy, but worth the money to keep the vacuum running properly. Would buy again.

Feature Product
- The Vacuum Cleaner Filter for Craftsman 17816, 9-17816 can be used for cleanup of everyday dirt like sawdust, wood chips, job site debris and car or truck dirt
- Dimensions: 8.5 H x 7 W inch; 6.75 inch. diameter; Item Weight: 4 lbs.
- Fully assembled; Available in white/red; Material: Paper Cartridge
- Fit most 5 gallon & larger vacs made 1988 & after
- You can save money by purchasing 2 packs
Description
Size: 2 Packs
Super air Vacuum cleaner filter for craftsman 17816 filter (2 pack)
The pleated paper technology creates an over sized surface area for efficient dust and dirt removal and can be easily cleaned These filters are washable and reusable.
Fits current vacuums 9-17784, 9-17761, 9-17066, 9-17741, 9-17742, 9-17765, and 9-17762. Will also fit older vacuums: 6 gallon manufactured since 1992; 8, 12, 16, 32 gallons since 1988 and 9-17923, 9-17932, 9-17935, and 9-17937.
Our filters also fit the craftsman vacs with the prefix "113" or "125" before the model number.
The model number of your vac is located on the motor housing. Check for the 113 or 125 prefix.
Product fit perfectly on my old shop vac. Was very pleased. Also came in 2 days--pleased about that, too.
Filter fit like a glove and works great. No problems, except the new type nut won't work on my OLD cleaner. I just looked in my junk till I found a hex nut to fit the shaft that the original plastic nut went on.
Filter fit my 16 gallon Craftsman shop vac perfectly. Getting 2 for what I paid more for 1 at Sears made them even better!
Purchased this for my 5 Gal. Craftsman Vac. Filter comes with a push on nut. This is not as good as the original with the threaded knob. Filter tends to fall off and can create quite a mess when the dust escapes.
This is still the best replacement I've found. Have read reviews from other buyers suggesting alterations for use with a standard nut.
The fit well and work well. I was able to wash and reuse without any problem.

0 comments:
Post a Comment